![]() ![]() Computers or any network peripherals that are connected to IP networks must be configured before they can communicate with other computers on the network. The Dynamic Host Configuration Protocol (DHCP) is an auto-configuration protocol used on IP networks. The Address 'A' record is the most important record that is stored in a DNS server because it provides the required IP address for a network peripheral or element. A DNS server stores several records for a domain name, such as an address 'A' record, name server (NS), and mail exchanger (MX) records. ![]() It converts human readable computer hostnames into IP addresses and vice-versa. Typically if a switch is in place and does not support PoE, midspan power injectors are used.Ī DNS server functions as a phonebook for the internet and internet users. The choice of endspan or midspan depends on the capabilities of the switch to which the IAP is connected. ![]() Midspan- A device can sit between the switch and the IAP. Power for devices is provided in one of the following two ways:Įndspan- The switch that the IAP is connected to can provide power. PoE is a method of delivering power on the same physical Ethernet wire that is used for data communication. The PoE source can be any power source equipment (PSE) switch or a midspan PSE device.Īruba power adapter kit (this kit is sold separately). IEEE 802.3af/at-compliant Power over Ethernet (PoE) source. Pre-Installation Checklistīefore installing the Instant Access Point ( IAP), make sure that you have the following: Įthernet cable of required length to connect the IAP to the home router. This section provides a pre-installation checklist and describes the initial procedures required to set up Aruba Instant. You are here: Initial Configuration > Initial Setup Initial Setup ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |